… The mixtures were shaken for 30 min on a mechanical shaker and then centrifuged at
3000 rpm for 10 min. pH of the supernatants were measured using a pre-calibrated pH meter (…

… , and further to 290 C at a rate of 6 C/min holding for 10 min. A DDT degradation check … 200
C at 3 C/min, followed by an increase to 285 C at 5 C/min and a hold for 30 min at 285 C. The …

… After annealing at 900 C for 5 min under Ar atmosphere, the … annealed at 900 C for 5 min
under Ar atmosphere. The XPS … to the short annealing time (5 min), the crystallization process of …

… maximum reflectance (Ro max) being up to 7.5%–8.2%, and minimum reflectance (Ro
min) is as low as 4.2%–4.5%. Results of Raman spectral analysis can basically reveal micro- …

Recently amorphous MoS 2 thin film has attracted great attention as an emerging material
for electrochemical hydrogen evolution reaction (HER) catalyst. Here we prepare the …

… Similarly, WL0’s WL to channel capacitance is the smallest because cross-sectional area
between WL and channel hole is the minimum among all WLs. On the contrary, along with the …

films were deposited by atomic layer deposition (ALD) using trimethylaluminum and as precursor
and oxidant, respectively, at growth temperatures ranging from room temperature to on …

… Annealing was performed in a rapid-thermal-annealing system at 650 C for 1 min in a pure …
Cure-annealing was performed after depositing the top Pt electrode at 400 C in air for 30 min. …

Most memory-chip manufacturers keep trying to supply cost-effective storage devices with
high-performance characteristics such as smaller tPROG, lower power consumption and …

… METHODS: Patients received 5 15-min sessions of 1 Hz cerebellar rTMS over 5 consecutive
days. Compliance and adverse events for the rTMS sessions were checked. The 10-m walk …